I need the advice of the market gurus.
I have a set of heads that I paid dearly to have reconditioned and machined by Bob Hurst/Anchor Atlantic to rebuild my motor. I have since decided to get PMO carbs and ditch the CIS. So I purchased another set of heads and had them machined and bored etc.. I would like to get a recommendation on what to sell them for in the forums/ebay.
These are date stamped 8-74
Here is the work performed.
Ultrasonically cleaned & glass beaded.
12- Manganese bronze valve guides installed & honed.
6- Exhaust valves replaced w/ 41mm (1mm o/s) & fitted.
6- Intake valves replaced w/ 47mm (1mm o/s) & fitted.
5- Exh. studs removed, holes repaired, 1- TimeSert &
S.S. studs, washers, nuts included.
Valves ground w/ 2 angles & seats cut w/ 3 on Serdi machine.
Cylinder seating areas machined (.013 thousands).
Cylinder head tops surfaced.
Valve springs tested OK.
Spring height & valve length set.
Assembled with new Viton stem seals
Here are some pics.
