|
Registered
Join Date: Dec 2001
Location: Off grid in Eastern ONtario
Posts: 236
|
Quote:
Originally Posted by Mark Henry
Is this the 901 trans stack alignment tool?
I have a homemade ghetto trans tool cut out of an old tranny.
Central ontario, I will lend it but I would want it back in short order.
|
This is the gadget:
If you are wiling , I'd make sure all is ready to go before I got the tool.
Shouldn't take long but there is always the possibility of it not going smoothly..........nah , never happens
I'd actually prefer one made from a case rather than trust one of the plastic ones.
PM sent
__________________
Bob D.
'84 Carrera - MAF, Wong chip, RSR flywheel, ER bushings and other bits, CTR fiberglass F/R bumpers, 7/9 Fuchs, 21/27 TB, 22/21 SB, bunch of other little stuff
'74 Fiat X1/9
2021 X5
|