[scarceller]

Also is the CHT sensor a 2 wire? see if you have 1 or 2 male pins in the white connector. If it's a 1 wire replace it along with the sensors.

When you replace the sensors I suggest you set the air gap for them as well.

The BMW sensors work great, they are exactly the same but the wire harness is a few inches longer. I use these BMW sensors often.

The harness side 3 pin female connectors rarely go bad, just spray them clean with good contact cleaner, then look at the actual female pins to be sure they did not get bent up. If they look good and are clean they are likely good. The male side of the harness comes with the sensors so that will be new.