|
Registered
Join Date: Dec 2001
Location: Off grid in Eastern ONtario
Posts: 237
|
To clean the MAF, I think it's best to remove the two screws that hold the sensor into the aluminum housing, and pull out the assembly, which includes the sensor wires.
It allows a proper inspection and cleaning.
Be careful with the fine wire coils.
Spraying into the aluminum housing might not get the fluid to where it is needed.
btw, the MAF works by measuring the air flowing through the small tube, then extrapolating that to figure out the air flowing through the main bore.
__________________
Bob D.
'84 Carrera - MAF, Wong chip, RSR flywheel, ER bushings and other bits, CTR fiberglass F/R bumpers, 7/9 Fuchs, 21/27 TB, 22/21 SB, bunch of other little stuff
'74 Fiat X1/9
2021 X5
|