Merry Christmas everyone.
Yesterday I spent a few hours on this little project, I'll call it my Rolex 24 Burn Barrel. I been wanted to buy or build a burn pit/barrel to take the the Rolex 24 at Daytona in January. I found this cool little barrel that was being thrown in the dumpster. It is 14 1/2" in diameter by 19" tall. I cut the ends out with a cut off wheel. I drilled some holes and added 1/2" threaded rods that had left over from my garage build. I probably didn't need to add the nuts and washers but it locks the rods in. I also added some rods in the inside. The legs are unistruct and were bolted on from the inside. It sits 14" off the ground so the ashes fall out. I'll try it out tonight.
