|
Registered
Join Date: May 2008
Location: Stavanger, Norway
Posts: 938
|
ok
with the current EDIS setup the VR sensor runs one EDIS module and nr 2 module is slave. EDIS1 talks to MS2 ECU and get back fuel&spark. If one were to go CDI, would the signal givers in for instance a JB distributor be used to run the CDI boxes, or to run the MS2 who would then send 2 spark signals; 1 for each CDI
What would be a good setup ? As I can see my MS2 has 1 only spark output not 2
__________________
80SC (ex California)
|