Quote:
Originally Posted by pampadori
Hey Mike,
To set your main VE and Ign maps to throttle % instead of map:
Wizards > Basic Setup > Engine > Main Spark Map Load Axis Selection = Throttle %
>>>>>>>>>>>>>>>>>>>>> VE Table Load Axis Select = Thorttle %
|
Thanks
I did actually do that, but for whatever reason it still didnt work... then I turned the car off.. and on again, and then it worked!
I also found my ignition trim and lambda trim tables were still set to MAP breakpoints but the axis was TPS.. so I copied and pasted the break points from normal lambda and ignition tables. Not sure how this trim tables are used, if at all, but car is driving.
Obviously, I have not found any perceived increase in performance or drivability since it's not been checked on a dyno. I have guesstimated my ignition map using exampes from this thread, and my own map. What I found intersting looking at the maps on this thead, is the difference between how much timing Jayson and Shaun are using. Also, everyone else seems to have much lower timing closer to idle, where my map uses 15-22 degrees.. will post a pic soon