Quote:
Originally Posted by LEAKYSEALS951
LOL- I was just doing this yesterday with some mower deck bearings. It felt like I put an entire tube of grease into each spindle. An eternity later, I could see the seals become taught, and when hand spinning the blades, a slight bead started to come past the seals.
It may be overfilled/bad on the seals, but if they don't, I'm always scared none/ not enough was going in there. When it leaks somewhat at the zerks insert, it's hard to tell how much is actually getting to where it needed to go unless it glops out the seals.
|
Try new grease zerks. The moment the head on the grease gun doesn't seal to a new zerk is the moment I replace the head on the gun.