|
Draco's post from 2016 below. Should be 11mm instead of 10mm.
"Check the door jam switches.
If they are there, remove the rubber covers carefully.
Use a 10MM deep socket and loosen the switch, then stop and get a 10MM box wrench and a needle nose pliers to hold the plunger as you slowly use the box wrench to remove the switch. The purpose of this is to keep from twisting the ground wire off and losing it in the pillar, NOT GOOD.
Clean the back side of the plunger very will as well as the pilar area of any rust and or debris".
It will unscrew. Gently remove it minding the wire. Use a hemostat or similar to keep the wire from falling inside while you clean up the switch.
Last edited by mo-mon; 04-18-2020 at 05:51 PM..
|