I took on this 944 race car build.
it's getting a wide body full roll cage and a LS3 motor swap.
I wasn't going to post the build but after thinking about it and asking the car owner if they would mind I decided to.
sadly the car owner cut the QTR panels off the car with the thinking they need to be cut off to install the new wider QTR panels. it was a big costly mistake! I had to make new back half of the QTR's and put them back on the car. the reason was because with out them the wheels are open to the inside of the car.
this car is only going to be used on the track for racing and track days.
after making the new back half of the QTR's and getting them on the car I fit the fiberglass rear bumper. and needless to say it didn't fit at all I had to make new bumper mounts and extend the bumper ends to meet up to the body.