|
Front and rear corners have an affect on all corners. To isolate, jack up one end and see what happens.
The factory repair manual describes a ”tripod method” to determine if each end is affected by the other. This requires lifting one end from a center location so only two front or two rear wheels are on the ground, thus the tripod support.
As Dannobee suggests, disconnect the sway bar end to make each corner totally independent. At this point. Measure and/or compare the ride height of the two corners on the ground, then adjust accordingly. The fronts are easy. The torsion bar rears not as much. Repeat for the opposite end.
Installing adjustable sway bar down links ensures there’s no/little/minimal weight jacking to affect ride height.
Sherwood
|