VR signal direct to MS2 which then fires two M&W S10 CDI ignition modules and two coils and a JB 12 point distributor
Now engine runs and idles well
However I still have two issues;
1) the CPU resets at random, every few minutes. Never did that before with EDIS
2) I used a strobe and set tooth angle until timing in tuner studio matched timing marks at 1200 rpm. However at different RPMs the offset set at 1200 RPM don't work. Timing mark on pulley matches as seen with strobe at 1200 RPM with a 77 degrees offset, but at 2500 RPM I need to change trigger offset to 60 to make mark on pulley match. With 77 degrees offset at 1200 I get the 10 degrees I have in the spark table, but at 2500+ I don't get the 25 degrees, but 35.
Grateful for any advice !
