Quote:
Originally Posted by Sooner or later
I see your problem. You can spin the handle to tighten up one side, but you can't spin the handle to tighten up the other.
The tiny nub and epoxy/adhesives for the other side is all I can think of.
|
You just made me realize it’s worse than that.
Not in the pic but there are actually two doors.
The current bolts for the knobs are closer together than the length of the handles.
So even if I can spin the 1st one on it will prevent the second from spinning on.
Think I’ll just try breaking the bolts lose and knocking them back into the cavity behind the door.
Drill the second hole slightly smaller than the bolt.
Thread bolts into the handle then slide them straight in using glue to secure.