Anyone here have any experience welding plastic? Maybe I'm just imagining this but I could swear that I've seen thick plastic welded just like metal(?)
Here is the deal; the fresh water tank in my RV has a broken off tube where the water fill hose connects. It's a clean break. I was thinking about cutting an access panel in the top of tank, fitting a new tube fitting from inside w gaskets and then closing back up the panel. Since it would be on top, leakage from the access panel is not a big concern but it still needs to be tight to keep contaminants out, etc.
I suppose that I could just epoxy it back together but if it can be welded, it seems like that would be better. I'll get photos tomorrow to better illustrate it, rig is in the shop right now getting windshield sealed, (again).
Thanks!
