[arbezc]

Thanks Rodney & 962, the links & comments are very useful.

I’d watch a few of the Garage Time clips but missed those two. Thankfully my floor pan is much less distorted. I hadn’t thought of a floor jack & sand bag with weights. I may copy a couple of his custom tools. I wondered about welding the pulling device to the outer seam. A clamp & pry bar would reduce the post weld repairs.

The videos raise a couple of questions:

Is the tunnel section of rear half of the pan essentially flat or should it have a slight bulge downward? The front section is clearly formed downward in the middle. My rear section looks flat but photos of replacement pans appear to have a slight bulge in the center.

In the last video, he uses Xylene to remove old carpet glue. I had planned to use Acetone or Lacquer Thinner. Is Xylene more effective or safer?