|
Registered
Join Date: Nov 2003
Location: Toronto, Canada
Posts: 79
|
Thanks 962,
I'll buy or make a Tram Gauge to check the above Dimension C from the inside edges.
That said, my 72 on Workshop Manual says "All dimensions are from centerline of hole & measured horizontally" in a couple of places. I presume they're meaning horizontal to the ground (level).
It would be useful if these floorpan holes on a 72-73 chassis matched the1200mm Dimension C on the 1975 floorpan drawing but I don't think they do. They aren't shown on any of the earlier "Check Dimensions" foldout drawings.
Would anyone know if there are welded take-up points for location C above on the 1975 & later 911 chassis?
|