[Rodney Nelson]

thank you everyone for your replies. Thank you for the suggestion about plugging the gun with your glove. I have already been doing that.

I went into the garage and found that there was some debris in the nozzle, so I was hoping that might fix it alone, but since I was already there I decided to remove the siphon pipe as in the video above, thanks dad911. I screened the media and started her up. Same results! It still is barely doing anything.

I know as Leakyseals951 said above I am at the low end of the cfm requirement. But there still seems to be a ton of pressure. I did find a leak at the gun inlet so I fixed that.

Another question is how often should I change out the media, is it possible that it is worn out? I'm using the media Black Silicon stuff from Harbor freight. I'm thinking I should just go buy a new bag as well.

What do you guys think?

Any input on what nozzle I should be using?

What about higher flow fittings and / or a regulator?

Thanks,

Rodney