Today I decided to modify the custom engine wiring loom that Dennis here on the forum made me when I went from CIS to Bitz.
Because this new system is using EDIS ignition I no longer needed all of the wiring to the coils and distributor as well as eliminating the AAR. I proceeded by cutting off the shrink wrap on the ends, being very, very careful not to slice my fingers... yea, you guessed it- sliced my middle finger, even after verifying it was out of the way! This is my world, smart enough to plan out a good strategy and dumb enough to mess it up anyway.
I removed the unneeded extra wires and put new shrink wrap over the junctions.
