Hi Mike, thanks. My PM is full so will respond here...
#1 - thanks for the SRP sheet, I didnt have that before and when I went to the ERP site last night to check documentation the site is under construction. I can see right away I need to flip the plate over to have the slot on the bottom.
#2 - Yes I saw your post about the locking washers last night as I was researching my problem. Thanks for that.
#3 - I have the stock arm mounts (though gusseted) You are right I have it on the low setting and have corner balanced her.
I will flip the plates this afternoon so the slot is on the bottom and see if I still have a problem getting camber adjustability back. I checked my spare suspension parts bucked and found these....I recall I initially installed the sway bar to the spring plate but found it less easy to adjust things independently so switched back to the stock sway bar mounting points. Perhaps one of these offset nuts will come into use...
Everyone likes pics so here's one of Gretchen...
