Quote:
Originally Posted by bweiss1
I am going to try this over the weekend. Any pics would be much appreciated.
|
I have the
V1 Power Adapter tapped into the yellow hot wire coming from the
ignition switch to the head unit, and to a ground. Power is on in all key positions except off.
I have my detector mounted in the upper left window:
Currently, I have the wire taped-down with electrical tape between the window seal and the frame; definitely not my best work, but the tape actually blends in well - barely visible. Trying to come up with a better application.
Bigger challenge is feeding the wire from the window to below the dash:
The crevices where the side of the dash meets the frame are extremely tight and I'm having a hard time keeping the wire in place. I'm going to see if I can figure out how to feed it alongside the left dashboard air vent to get it under the dash vs. how it is now; needless to say, I want to avoid drilling holes. Open to any recommendations on how to better run the wiring.
Hope this helps!