[jyl]

I'm about to place an order for some G-Force harnesses and Brey-Krause mounting hardware. I would appreciate it you guys could look over my list and tell me if I'm ordering the wrong part.

This is for a 89 3.2 Carrera, street / AX / later DE. I am keeping the OEM belts and want to be able to easily clip and unclip the harnesses. I will be using a harness bar guide (until I get a rollbar) but anchoring the shoulder belts at the rear seat lap belts. Using racing seats.

Planned order:
- Harness: G-Force 5-point pull-down camlock with H-shoulder strap (GF-C5030). Is there any disadvantage to the H-shoulder?
- Belt end: G-Force snap hook belt ends (GF-107). I was going to use this part on all five belt ends (shoulder, lap, crotch).
- Mounting hardware:
- lap belt inner mounts: Brey-Krause tunnel side belt mount (R-9002)
- lap belt outer mounts: Brey-Krause outside belt mount (R-9003)
- shoulder belt mounts: G-Force 1/2" eyebolt (GF-109) is this the right thread for the existing rear seat lap belt mounting points?
- crotch belt mount: G-Force 1/2" eyebolt (GF-109) with large backing plate (GF-100), bolted through the floor. Is the floor material thin enough for a 1/2" bolt?