Quote:
Originally Posted by billybek
So how did you extend the wiring harness?
|
http://forums.pelicanparts.com/off-topic-discussions/1104139-german-plastic-wire-connector.html I think that is next on his list
---------
I learned a little more about plumbing..considering their $1,000 quote for sub$100 in parts did not fit the budget.
It was a FU quote from a company I've done business with many times and on good terms. So disappointed. The old man was crotchety.
Contractors are pretty busy these days.
There are usually 3 types of shut-off valve connectors:
1). Solder on. This is a pain obviously and needs enough room to not run to the fire extinguisher. Sharkbites seem to be popular but I've never used them.
2). Compression nut. If they are not round or damaged the brass ferrules can be carefully sawed off to split and the pipe stub cleaned up smoother with emory cloth. If in good condition the ends can be re-used. Add a very thin smear of plumber's paste at the very outer threads (plumber's putty is only for creating base gaskets). Nothing should interfere with the threading. It's just a backup.
3). Screw on. A threaded piece of pipe thread sticks out of the wall. Look for the lack of a split which indicates #2. These are old style and not common.
There are usually 3 sizes of shut-off valve connectors:
1). 3/8". Old style and difficult to find.
2). 1/2"
3). 5/8" (which go onto 1/2" copper pipe) are most common I think. IDK.
Sink drains are usually 1.5" and toilets are 2" PVC.
Mine were 3/8" threaded which are practically unicorns to find.
The box stores didn't even carry these...only the local ACE(s) and they only had a couple in stock.