I have a question on staining wood. I stained my beams that I made and there are a couple of spots where the stain did not soak in, causing a couple of light spots. I'm wondering if I touch up these few areas and allow to soak in, will I be creating dark spots and should I just re-stain the entire beam.
Any Advice?
Photos below show the project start to Current Status. Last photos show my problem areas:
Almost Finished but before Polyurethane:
In the Beginning: Opened up Wall, Installed GluLam Beam
Constructed Beam Box Covers:
Burning & Distressing:
First Pass Staining:
First Issue: Stain Did Not Soak In Completely
Second Spot Not Soaking In:
