[Jonny042]

Of those of you that have used ACL rod bearings, have you measured oil clearances of either one and can provide a little guidance on the resultant oil clearance?

Planning to use them for my 3.4 build based on the 3.2 bottom end. Nice to be able to choose the extra .025mm oil clearance but not sure I want it.

Usually I have the rods re-sized after I have bearings in hand and have measured the clearance and get the rods sized to push the clearance in the direction I want. In this case I may use new rods so don't want to be farting around with that.

I don't want to purchase two sets of bearings if I don't have to.