I removed my HVAC control to clean it up in preparation for the new fascia. This meant undoing a bolt under the dash that was a PITA to get to. Much upside-downess happened. Said inversion was easier with the steering wheel removed:
Note to self, buy new bolts for that. Didn't realize the existing ones were torqued on by a gorilla. Anyway, I removed this bolt:
And pulled off a single ground, then popped the HVAC controller out:
Tracing the wires lead to this plug:
And a single wire that went to the glovebox:
Then I could pop it out:
And remove the bowden cables, which will all eventually be replaced with new ones I've got in the office. (foreshadow!) Here's the unit ready for cleaning:
But, ADD is real. So, on to the next project instead.