(cont)
Should JUUUUUUST fill the crack between the door card and the outer ring of the knob surround.
While that was printing, I screwed some stuff into the new door card:
Attached the pull strap:
Then the door card:
Lock knob and 3D printed ring...
Yup, the new ring DOES make a difference. I think I might wanna print another one that's about twice the thickness so the vinyl gets pushed in a little bit like around the power window surrounds and pull surround.
And top garnish. This one had the holes pre-drilled. I mean, still in the wrong spots - I had to drill a new hole in the door to get it to set properly. But not a huge deal. Just not something I expected from an OEM part.
And that's that. On to the next project!