(cont)
OK, 3D printing isn't going to work. Especially if I don't lay it out right. But what if...
Yup, that'll do. I mean, it's supposedly a heat-set insert, but 750*F on a soldering iron didn't melt the plastic, so I used a vice instead.
Ready to be reinstalled.
But I needed sleep at this point, so how about I swap out my steering wheel real quick first?
Oddly, I'm not a huge fan of it. It's a bit too modern, too... Gas station knife. Plus, it's not dark enough! I might need to pick up a simple round wheel with none of these fancy thumb grooves. I believe they're called Prototipos? In a nice, big size, too, so that I can see the gauges!
Unboxed blower:
Not all of these ports will be used. Need to cap a few.
Cap printed:
