Quote:
Originally Posted by 911hillclimber
The XDi has a light.
Limited, but it starts on a solid Green on Switch ON. Crank the engine and the solid greed should go Green/red alternating.
On my unit the light stays solid Green until you stop the starter, then the light goes solid Red.
In the diagnostics section of the manual this fault is described.
It concludes this situation means the sensor is faulty and/or the Xdi is not catching the sensor signal.
As you can see, the signal is good the resistance of the sensor should around 620 ohms, mine is 618. Clewett state this is ok.
This light condition/sequence has NEVER changed no matter what I try/have done, yet Electro state it tested 'Trouble-Free'.
There has never been a spark anywhere, anytime.
P935:
There is no laptop hook-up. There is no remote facility to fix anything, all is sealed.
So:
All wires safe and sound
XDi box checked at the factory, trouble-free.
VR sensor sending out a great signal.
But no spark.
|
Xdi box is grounded as well, correct?
On my xdi the only issue I ever had with no crank sensor was when a wire pulled out of the plug.
How did you go about testing the existing sensor? Is it possible there is a problem between the plug on the sensor and the plug on the main harness?
My gut says it's a wiring issue.