Good morning friends and frenemies!
I've recently installed an ECU Master EMU Black on my SC. I installed a 993 CHT sensor above cylinder 4, but it's not the best solution for engine temp. My engine can be at full temp, but driving in a cold rain and the CHT will read low.
So I've purchased a Bosch oil temp sensor. (Bosch pn 0280130026) I intend to install this new sensor in the engine and to then use the oil temp as engine temp. The car is still NA, so I don't need it to react to rapidly changing oil temps. I need it to be stable and to actually let the EFI know when the engine is up to temp.
So my question is this.
Where on this engine should I mount the sensor?
I've been told the breather cover will work, but it won't be a stream/bath of oil. It'll just be inside the engine and exposed to oil vapor/spray. This would be my preferred location as it'll be the easiest to wire.
There's also the bank 1 chain case, but IDK if it'll get into the cam gear because of the length of the sensor. And it'll have the same problem with not being immersed in oil.
Any experience/insight will be greatly appreciated.
Pic for attention
