We got our cylinders back from EBS. 2,7 bored to 92mm. Bores look good.
However when I measured the cylinder heights some of the cylinders were not perfectly square.
One cylinder in particular measured 3.354" on one side and 3.360" on the other.
So the question is will this work, or do I need to send them out? Or clean them up on a glass plate with 400 grit?
Two other cylinders were also not square, but not as bad as that one.
What say the brain trust?
__________________
Gordon
___________________________________
'71 911 Coupe 3,0L
outlawed
#56 PCA Redwood Region, GGR, NASA, Speed SF
Trackrash's Garage :: My Garage