[rfuerst911sc]

Hello I recently purchased a 1999 Porsche 996 C4 and one of the hard brake lines in the rear is quite rusty . It is driver's side and fairly accessible . A little online research says the line is 3/16 diameter .

So I believe the repair consists of buy section of new tubing , cut old back to " clean " and then flare everything . Is that it in a nutshell ? All other lines look good . At the same time I will replace rotors and pads along with soft lines to get everything up to snuff . And will flush/bleed with new fluid .

I have watched a few videos so I think I got this but any tips/suggestions anyone has is appreciated .