Hi Wayne / Sherwood,
Thanks for the response & advice - will take your suggestion & eyeball it
Wayne, about your comments on turbo pistons -
Quote:
|
Also, the Turbo pistons are different than the typical CIS pistons - they are flat to begin with...
|
It means that I can safely use the vernier caliper to measure the height then?
In my case, I found out that the PO had shaved the head. I'm also changing cams & I got a very good set of P&Cs which sadly also had been shaved a tiny bit, so I want to be doubly sure that I'm not bumping my compression beyond safe & there's no valve clearance issues.
thanks again.