Greetings,
I'm finally into removing the dents in my 911's floor pan. Unfortunately several are under the sills & are inaccessible form the inside of the car. Here's a shot of the worst dent in the right rear corner.
I'm considering using a Stud Welder & Slide Hammer to pull the dents out from the outside. For a little more $$ there are Dent Puller Welders such as the one below where the weld is made directly on the end of the slide hammer tool.
I don't have experience with either. I'm thinking Studs & a Slide Hammer may be better for deep dents but a Dent Puller would allow many smaller pulls without as much damage. Does anyone have advice on how useful either device may be for the floor pan?
Thanks,
Charles