|
I used a cheap HF stud welder and slide hammer think it was $100. Does what it’s suppose to do. Some of those dents will not pull all the way out with just a slide hammer there’s just not enough force especially in curved areas and corners. I just finished what your tackling and I don’t envy you. I ended up stripping off all the chip guard down to bare metal. Learn to use a dolly and hammer properly simple tools can get a lot done in a short amount of time. I don’t think spending $300 or more on a stud welder is going to give you an advantage over the cheaper HF $100 one. The HF worked fine for me essentially all your doing is welding on a copper coated stud.
|