Quote:
Originally Posted by mysocal911
1. The single wire temp sensor is measured to chassis ground.
2. On ref & RPM sensors, there're three wires for each (one is a shield).
Only one of the three connection combinations should indicate a resistance measurement.
3. It's unlikely that all three sensors are bad.
|
Yes thank you I know the CHT is to ground I was just remarking that the Bentley shows 2 and they also show over 1000000 ohms for for the other combinations on the speed and reference.
Anyway I had another look and got the correct reading on the reference sensor after cleaning the terminals a bit but the CHT and speed are completely dead