Hi Everyone
After a previous problem with a spun crank bearing, seems my cam-towers are 'shot'. I had sent them to Ollies and Zach advises the bearings are too scored to rework. Looks as if some bits from the crank bearing made their way through to there.
I'm really inexperienced at all this and not sure where to go from here with my baby. Zach recommended replacing them, so did some looking around and cam-tower pricing seems all over the place from $200 - $2000. With prices closer to the high-end for the 930 105 021 00 ones.
Just wondered if anyone could give me some sage advise on what would be the best course of action or have any suggestions, please. Thank you
Everything else is ready to go. Armand CCS redid the crank to std/std. Oil tanks and cooler cleaned by Pacific.
Regards from a much cooler Dallas
Mike