|
Two way to do this. make a router table and clamp a fence to it. Set it up once, multiple pieces can be cut accurately just like the pic above. If you do this once in a blue moon, no use spending money on router table. mount router under a piece of plywood or sheet stock, clamp fence or use a straight piece of wood on both end. Test a piece and run 'em all.
Method two is to make a shooter board for your router. see pic. First, the router must run down the board and cut the lower portion of plywood. Each and every time you line up the cut edge of the board (shooter board) to the edge of your board you like cut, it will cut at the exactly same place each and every time.
|