|
Well, you are in pretty deep there, better you then me. You did asked for opinions, could you weld on the new piece higher up to make sure you clear the tire when it travels up? If you get a large solid piece of wood and a large ball peen hammer you could put some 3d shape into the section you are welding on. To fill any openings with mig wire you could try a piece of 3/32 or 1/8 copper sheet under where you are welding as a back support.
__________________
87 930,
Last edited by 908/930; 12-07-2022 at 01:28 PM..
|