[targaguy]

Hi Guys,

I have owned my 996 Targa for four years. I rebuilt it after an engine fire and it is mostly done. The resurrected engine runs great, but I have a mystery to solve in the rear suspension.

I noticed that the right rear fender arch is 1/2" lower than the left, on the original, worn-out factory Bilsteins, set to standard height for US specs. I cannot afford M030 or other new suspension sets right now, so I bought used Bilsteins from a low-mileage 2001 911. I just installed them and they fit perfectly, but the "sag" on the right side is still there. I have not driven the car after the installation today, but I wonder if the low side is caused by engine mounts. The interior of the car was not scorched at all. Wheel well saw no flames either.

I'm stumped. Any suggestions will help.