[vjz]

This week I am hoping to start putting back all of the stuff I have removed so I can start testing the running condition.

I found that there were some brittle vacuum lines (mainly from the WUR to the thermo vacuum valve, and then up to the T fitting behind the rubber throttle/sensor plate intake cover. I replaced that as well, because there was a massive rip underneath it.

I went to the local parts store and it didn't seem like they had anything that fit very well on the shelf. What size should I be on the lookout for? I have another place I can check on Saturday in town.

I deleted all of the auto heater crap and plan to backdate that at some point. Seems fairly straightforward if you buy the right side heater duct.

Also, is there any decent place to relocate the thermo valve so that I don't have to install the auto blower motor bracket back in? I know the two injector hoses clamp to that, but I felt I could make a different bracket that is hidden a bit more. I am liking the way the engine looks with less stuff in it!