|
You’re over thinking this. If you look at the PVC pipe you have there is print all down one side of the pipe. So you already have a straight line to work with. Just clamp one end in your vice to where it looks like the print is straight up, hold the drill, perpendicular to it and drill away. It doesn’t have to be perfect. Just close enough will do. Repeat on the other end. The only measuring you should have to do would be how far in you want to go on either end. But you could probably eyeball that. I can’t imagine it would take more than a couple of minutes start to finish.
__________________
Kurt V
No more Porsches, but a revolving number of motorcycles.
Last edited by Rot 911; 06-19-2023 at 06:37 PM..
|