Yesterday's effort was focused on the evaporator box. Lots of little details to take care of:
making things line up properly,
installing the new evaporator blower motor,
clearancing for the evaporator exit tubes,
sealing unneeded holes,
locating and making a hole for the thermostat probe in a good location,
dressing slightly bent fins,
weatherstripping air paths for better efficiency,
rerouting my previously modified fresh air drain,
trimming the outgoing flex duct to be able to allow the eval box install,
installing and sealing the footwell connection piece after removing the resistor pack bracket,
buying and installing new bolts, washers and nuts to the two halves (6mmx1.0 X 20mm long).
I need to find my other eval box bracket - the one that attaches to the rear bulkhead to finish the install.
