Quote:
Originally Posted by Joesmallwood
I ended up going with this:
It's a Zada Tech Display that I designed a 3D printed bezel for.
It works beautifully for dual AFR.
I have been working more with Zada Tech and could likely get whatever you wanted in the same form factor that could display dual readouts of anything you wanted. It can also be designed to rotate through many more outputs with a small joystick (dial). |
That is fantastic....I am just about to get into 3D printing as I need it for my custom centre console front (which I will post when done), so the bezel you show makes perfect sense.
I will check with the Zada people and see what they have, sounds like there is a good solution over there. I would prefer a CANBUS connection as I already have an output run from my Motec, but an alternative might be to just tap into the O2 sensors in parallel with their connection to the Motec...I assume they just sense voltage so ought to be able to feed both the Zada and then Motec without issue. May have to research that point for a bit.
Thanks so much,
D.