[JW2000]

So I have some damage on the seam about 6 inches near the bottom oil pump cover.

its on the outer edge of the seam.. Raised up about less than 1mm. It appears its from people jacking up the car from the engine.

1. Do I get a flat metal block with sandpaper and just sand the edge down on both cases... If so what grit sand paper? should i also block the entire case with sand paper as well?

or

Do i leaven it alone?....thinking even though the seam got dented, both sides of the case dented together which would make me think they would fit back in together.?

thanks