[OG911]

plastigage results: rods all at .002 or better- only item of note is wear evident at #3 - it is "fingernail-worthy"- should i conclude it is to be replaced?- and if so, only that rod set?- all other surfaces very nice



mains at .002, except #4 at say .0025- bearing surfaces smooth, with no pits or scoring- pic is typical of all mains- what advice re replacing #4



re rocker shafts- confession here!- you tube makes it look easy- wasnt bad for most but i struggled mightily(!!) with last two- intakes #4 and #5- twisted a 5mm allen in the process- nothing worked- even tried drilling- i finally drove them out with a drift - (two new shafts added to order) -from here, any necessity to refinish inside of cam housing thru which they were driven?- and any necessity to refresh rocker bearings generally in absence of issues?