[boyt911sc]

Remove all the metal screws around the seam of the air box. To split open the Airbox, you need to apply heat using a heat gun and start at the opening where the throttle body is located.

I use a specially designed contraption to pry the upper section from the lower section and apply moderate amount of heat to unglue the top and lower sections. Do not over heat the plastic Airbox! Apply gradual lifting pressure without breaking the Airbox and continue heating the perimeter using a heat gun. Or use the kitchen oven when the BOSS is out shopping. Temperature below 300°F is enough to split open the plastic CIS Airbox unless someone applied JBWeld earlier.

Patience is your FRIEND.

Tony