Quote:
Originally Posted by Thorndyke
Good to know about Alusil, I don't have to deal with it in this case but will look into it more just out of curiousity (and the possiblity of running into it in the future).
@Alan L, is "land clearance" the same as "side clearance"? If so, I think that I measured it as OK with the existing rings, but will check it again and for sure will check it with new rings. Good point, and thanks for that!
|
Feeler gauge between the ring and the top, or bottom of the land (groove) it is sitting in.
Alan
__________________
83 SC, 82 930 (track) - Stock except for RarlyL8 race headers, RarlyL8 Zork, K27-7006, 22/28 T bars, 007 Fuel head, short 3&4 gears, NGK AFR, Greddy EBC (on the slippery slope), Wevo engine mounts, ERP rear camber adjust and mono balls, Tarret front monoball camber adjust, Elgin cams, 38mm ported heads, 964 IC. 380rwhp @ 0.8bar Apart from above, bone stock:-)
|