|
Set the timing first.
Adj. valves.
Mess with carbs last.
Make sure you have some free play in the throttle and choke cables
You should use a Uni Syn tool to check carb balance.
If you have a suction leak from the carbs it is from the throttle shafts.
They have brass shafts that ride in a aluminum carb body.
The brass wears and the carb body get egg shaped.
There is no O ring on the throttle shaft.
There is no rubber diaphragm its all aluminum.
I don't know if you have a hp cam or not but it still shouldn't idle that high.
The trick for the top is the frame is spring loaded.
you put the bows on in the closed position with the with the springs in the lower position.
Then you put the top on. Open the bows and release the spring tension.
There is a valve on the cyl. head that you turn on for the heater.
|