Quote:
Originally Posted by Schulisco
1. Did you ever checked the WUR control pressure (cold and hot)? It must be in factory spec:
2. How many turns do you need to close the idle screw? (remember original setting and set itback afterwards)
3. Does the fuel pump run when you switch ignition on only?
4. Check the sensor plate height and adjust it if not in spec as described in the manuals:
5. Ignition timing is correct? Will say not too sharp, idle ~5°?
Thomas |
Thomas, will check pressures when I get home, they were checked and within spec a couple months ago before I swapped in the previously mentioned new components. The fuel pump does run when ignition is switched on. when I plug the airflow sensor wire in the pump does not come on. currently leaving the wire unplugged. Ignition is set to 5 degrees. will also check idle screw for how far out it is and put a feeler in the sensor plate for correct spec, i have not disassembled any of those components but will ensure and adjust if necessary. Also might add that when the sensor plate is pulled down the engine sputters up more. Thank you for the pictures, are these from the bentley manual?
Joseph