|
Funny you should ask this question as I spent most of yesterday installing a set and had a nightmare doing so. One of them cracked on the top and ended up having to grind down the top part of the lip on the fender to have them actually seat on the right hand side.
I also had problems getting the trim ring to stay in place on one side. It’s there now but I suspect it will pop off once on the road. Right now I can’t give you much advice in terms or retaining the rights, but the design of having them loosely seated on a piece of 3D printed plastic doesn’t seem durable.
Now mine were purchased several years ago so may be an older version, but I see above that there is a new version which also appears to have issues with the design.
If you aren’t looking to buy expensive LED ones then perhaps look at old factory units available on eBay?
|